Programeren sleutel 3 knops afstandsbediening.
Geplaatst: vr 20 feb 2015, 3:34 pm
For the 3 button remote the programming procedure should be the following:
1. Put the key in the ignition and turn it to position II and back to 0 four times very quick.
2. When you remove the key the LED on the clock should light up constantly.
3. Whithin 20 seconds press any key on the remote that you want to program.
4. The LED should flash now to indicate that the programming was successful.
5. To end the programming mode wait 20 seconds or switch the ignition on.
met dan aan Pumapeople uk.
1. Put the key in the ignition and turn it to position II and back to 0 four times very quick.
2. When you remove the key the LED on the clock should light up constantly.
3. Whithin 20 seconds press any key on the remote that you want to program.
4. The LED should flash now to indicate that the programming was successful.
5. To end the programming mode wait 20 seconds or switch the ignition on.
met dan aan Pumapeople uk.